







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Unilock Fence Installation: The Enterprise Owner’s Guide
Unilock-compatible fence installation in Enterprise typically costs $3,500 – $9,000 installed, and the work is scheduled as a planned project – we walk the line, match the Unilock system already on your property, and give you a written price before anything gets dug. Most owners don’t wake up thinking about fence parts. They notice it on a Tuesday: a post that leans a half-inch more than it did last month, a panel that rattles when the wind comes off the desert, a gate latch that stopped catching. By the time the leaning gets obvious, the footing or the fastener set is usually the real story, and the Unilock system on top is just what you can see.

Which Unilock Models This Applies To

Unilock makes a range of hardscape and boundary systems, and the fence line sits at the intersection of several of them. What matters on your property is the system the existing fence uses, not the name on the brochure. So we start by reading what’s already there. Look for these identifiers before you call:
- Post collar and cap profile. The shape of the post end tells you which series you’re working with. Square caps and chamfered caps are different systems and don’t swap.
- Panel spacing at the pickets. Measure the gap, not the board. A half-inch difference is a different spec.
- Footing reveal. How much of the footing shows above grade tells us how the post was set and whether the replacement needs a deeper pour.
- Labeling. Unilock stamps or tags often live on the underside of a cap or the inside face of a terminal post. Take a photo.
On the OEM-vs-aftermarket question for Unilock specifically: genuine Unilock components are worth it at terminal posts and gates, where load concentrates. For mid-run pickets and caps, a quality aftermarket match in the same profile is a fair call and saves meaningful money. We’ll tell you which is which rather than upselling the whole line. Mason Remodeling Enterprise is an independent service provider, not affiliated with Unilock.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Unilock Fence Installation Is Failing
- Leaning terminal posts. Usually a footing that wasn’t poured deep enough for Enterprise’s caliche-heavy soil, or water sitting against the base. The post itself is fine; the ground gave up.
- Rattling or loose panels. Fastener corrosion or a bracket that was never torqued. Common after a few summers of 100-degree days cycling the material.
- Gaps opening at the joints. Thermal movement working against a footing that’s shifting. If the gap grows season over season, it’s the base, not the panel.
- Gate sag and latch miss. Hinge plates pulling from a post that’s rotating slightly. Left alone, it tears the post face.
- Efflorescence and surface chalking. White bloom on the face after monsoon season. Sometimes cosmetic, sometimes the first sign water is trapped behind the system.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Fence installation in Enterprise runs $3,500 – $9,000 installed. That’s parts, labor, removal of the failed section, and disposal. What pushes you toward the top of that range: longer runs, more terminal posts, gate hardware, and footings that need to go deeper because of what’s under the ground. What keeps you near the bottom: a short run, sound footings, and a single section swap.
You get a written price before any work starts – line by line, parts and labor separated, no verbal estimates that grow on the final bill. If a repair or installation fails within 365 days of completion, we come back at no charge. That’s the 365-Day Done Right Promise, and it’s in writing with the terms spelled out.

DIY or Call Us?
Here’s the honest split. You can safely walk the line, photograph the caps, measure picket gaps, and note which posts lean. That information makes our quote faster and more accurate. Where fence work goes wrong for a homeowner is below grade and at load points: digging out a footing in Enterprise’s soil without hitting irrigation or utility lines, re-setting a post so it actually holds, and hanging a gate so it doesn’t sag in six months. Those aren’t safety hazards the way electrical or gas work is, but they are the difference between a fix and a repeat. If you’re unsure what failed, don’t guess at it. Call (844) 797-6157 and we’ll tell you what we’d check first.
FAQs

Expect 15 – 25 years for the system itself when the footings are right, and that range shrinks fast if the base was set shallow. The material handles desert heat well; the footing and fasteners are what decide whether you get the top of that range. Call (844) 797-6157 for an assessment of what you have.
Often yes, especially when it’s one section or a single terminal post. If the panels are sound and only the footing failed, a targeted reset costs far less than a full run. We’ll tell you plainly when repair is the smarter spend. Call (844) 797-6157 for a free look.
A single section or post reset is usually a one-day job. A full run with new footings typically takes two to four days depending on length and how much digging the ground demands. You’ll get the timeline in writing with the price. Call (844) 797-6157 to schedule.
We spec the part from your existing system’s profile and measurements, then source from professional-grade suppliers, with aftermarket equivalents offered where they’re a fair match. We don’t claim to carry parts on a truck or hold stock. The written quote states exactly what’s being installed. Call (844) 797-6157 to start.
We also work with KraftMaid, Cambria, and Silestone on the projects that touch your home’s interior, so the same crew relationship carries across the property. If you’re ready to know what your fence actually needs, call (844) 797-6157 for a free estimate. A live person answers, day or night, and you’ll get a written price before we touch a single post.
Written by the team at Mason Remodeling Enterprise, serving Enterprise and nearby areas.












