







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Sakrete Home Additions & ADU: The Enterprise Owner’s Guide
If you’re planning a home addition or ADU on the same property as an existing Sakrete-built foundation, patio slab, or structural wall mix, we install and finish those projects in Enterprise. Home additions here typically run $45,000 – $130,000, and detached or attached ADUs run $90,000 – $220,000 depending on size and site work. We’re an independent construction company, not affiliated with Sakrete, and we schedule these projects around a written plan rather than promising same-day anything.

Owners usually discover the underlying problem the hard way: a slab edge that has started to break down, a cold joint pulling away from a wall, or surface flaking after a hard winter of freeze-thaw in the east valley. Sakrete is a mix and materials brand, not a single “part” you swap out, so this guide is really about how to tell good Sakrete-compatible concrete work from the kind that cracks in year two, and what it actually costs to get it done right in Enterprise.
Key Takeaways
- Additions: $45,000 – $130,000 installed in Enterprise, depending on square footage and foundation type.
- ADUs: $90,000 – $220,000, driven mostly by whether you go detached or attached.
- Concrete mix choice, not just brand, is what determines lifespan in our climate.
- We provide a written price before any work begins, backed by our 365-Day Done Right Promise.
Which Sakrete Models This Applies To

Sakrete doesn’t make a “home addition part.” It makes concrete mixes and surface products: high-strength concrete mix, fast-setting concrete, sand mix, mortar mix, and crack-resistant patching lines. The mix matters because your addition or ADU foundation, slab, and any masonry work all depend on getting the right formula for the load and the climate.
To identify what you’re actually working with, look at the original bag labels if any were kept, or check the pour date and mix spec in the permit file. In Enterprise, permit record requests go through the city, and a copy there will tell you the concrete compressive strength and slump the original contractor was required to meet. Where those records are missing, we measure slab thickness and curing condition onsite before quoting.
On the OEM-versus-aftermarket question: for concrete mixes, there isn’t really an aftermarket. Sakrete is the mix. The real decision is whether the bagged product is right for your application. High-strength mix is for structural use; fast-setting concrete sets in about 20-40 minutes and is meant for post holes, not a footing you’ll load slowly. Using the wrong line is the most common failure we see. We also handle KraftMaid cabinetry, Cambria and Silestone countertops when additions include interior build-outs.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Sakrete Home Additions & ADU Is Failing
- Surface flaking or scaling. This is concrete spalling, usually because the original pour saw too many freeze-thaw cycles without an adequate air-entrainment admixture. In Enterprise, our winter nights frequently drop below freezing and warm fast in the morning, which stresses a poorly mixed slab hard.
- A cold joint that pulls apart. When a new pour is added to an old slab without the right bonding method, the two surfaces separate over time. The joint opens, water gets in, and the failure accelerates.
- Hairline cracks widening over months. Small cracks are normal. When they widen, it usually points to inadequate subgrade preparation or a slab poured too thin for the load sitting on it.
- Foundation edge crumbling. Corner and edge breakdown is often a sign the mix used was too lean, meaning not enough cement relative to aggregate, and it simply won’t hold an edge under a wall load.
- Soft, chalky surface texture. That look is usually a curing failure, where the slab dried too fast after the pour. It doesn’t necessarily mean the whole slab is bad, but it’s the first thing we inspect before any addition goes on top.
Replacement Cost & What’s Included

Home additions run $45,000 – $130,000 in Enterprise, and ADU construction runs $90,000 – $220,000. Garage conversions, which are a common low-cost alternate route, run $30,000 – $80,000. Those are installed ranges, not bare construction figures.
| Project | Enterprise Range |
|---|---|
| Home addition | $45,000 – $130,000 |
| ADU construction | $90,000 – $220,000 |
| Garage conversion | $30,000 – $80,000 |
What drives the top of that range: site grading, utility relocation, foundation upgrades where an existing Sakrete slab won’t support new loads, and permit review timelines. Every project gets a written price before any work starts. No surprise invoices. Every project is covered by our 365-Day Done Right Promise, and if a repair or installation fails within that year, we return at no charge.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can safely measure a slab, photograph a crack, check your permit file, and pull the original mix spec if it’s there. What you should not do yourself is anything involving structural loads, foundation repair, or cutting into an existing foundation to tie in a new pour.
That’s not a scare tactic. Getting a foundation tie-in wrong creates water infiltration paths and load failures that don’t appear for a year or more, and by then they’re far more expensive to fix. Contact (844) 797-6157 for a free estimate. We’ll tell you plainly what needs to be replaced, what can be repaired, and what it costs.
FAQs

A properly mixed and air-entrained Sakrete pour generally holds up for decades in our climate, but that depends heavily on subgrade prep and curing. We see slabs in Enterprise show serious surface breakdown in as few as 8-10 years if the mix wasn’t rated for freeze-thaw. Call (844) 797-6157 for an exact assessment.
Often, yes. Small cracks and localized spalling can be patched with a proper repair mix if the underlying slab is sound. If the subgrade is failing or the slab is cracking through the full depth, patching it just delays a larger problem. We assess and give you both options with prices. Estimates are free.
A slab repair can be done in a day. A full addition or ADU takes weeks depending on size, permitting, and foundation work. We give a written schedule with your written price before any work begins, and we don’t start until you’ve approved both. Call (844) 797-6157 to start the estimate.
We buy Sakrete concrete mix through verified building-supply channels, matching the specific product to your load and climate requirements. We don’t stock materials in a warehouse, and we don’t carry parts on a truck, so the right mix is ordered per project. Call (844) 797-6157 to talk through your project.
Ready to price your Enterprise addition or ADU?
Whether you’re working from a Sakrete mix on an existing slab or starting fresh, we give you a written price, an experienced crew with up to 22 years of experience, and a full 365-Day Done Right Promise on the work. Call (844) 797-6157 for a free estimate.
Written by the team at Mason Remodeling Enterprise, serving Enterprise and nearby areas.












