







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
IKO Kitchen Remodeling: The Enterprise Owner’s Guide
IKO-compatible kitchen remodeling in Enterprise typically runs $14,000 – $45,000 installed, depending on cabinet layout, counter selection, and whether you’re changing the footprint. IKO is a manufacturer known for roofing and building products rather than a kitchen cabinetry line, which is the first thing Enterprise homeowners should understand before they price anything. Many of the calls we take start with an IKO-labeled underlayment, mat, or moisture barrier found behind a failing backsplash or under a sagging toe-kick – the product was part of the last remodel, and the remodel itself is what’s failing now.

What that looks like in practice: a soft spot under the sink, grout that won’t stay put along a backsplash line, or a cabinet box pulling away from the wall because the barrier behind it trapped moisture. In Enterprise, we regularly see this in homes where an earlier remodel used IKO building products correctly but skipped the vapor detailing around wet zones. Knowing which IKO component is installed, and where, is step one before any quote is honest.
Here’s what this page gives you: model identification, symptoms, Enterprise pricing, and an honest line between what you can check yourself and what needs a trained eye. Mason Remodeling Enterprise is an independent service provider, not affiliated with IKO, and we don’t claim to stock IKO parts or carry them on a truck. We source them for the job, verify them against the model, and install to the manufacturer’s spec.
Key Takeaways
- IKO is primarily a building-products manufacturer (roofing, waterproofing, underlayments), so “IKO kitchen remodeling” usually refers to IKO products used inside a past remodel – not IKO cabinets.
- Typical Enterprise kitchen remodel installed: $14,000 – $45,000; smaller scopes from $9,000.
- Identifying your exact IKO product line and lot is what makes an accurate quote possible.
- We deliver a written price before any work starts – always.
- Every project is covered by our 365-Day Done Right Promise.
Which IKO Models This Applies To

IKO manufactures roofing shingles, waterproofing membranes, and underlayment products. In kitchens, the IKO components we encounter most are moisture barriers and seam tapes used behind backsplashes, under cabinet runs near sinks and dishwashers, and along floor transitions. If your last remodel was documented, the IKO product name and lot number will usually appear on a label tucked behind a drawer box, on a roll edge, or on the homeowner packet the previous contractor left behind.
To identify the right part, look for three things. First, the product name printed on the membrane or tape edge – IKO prints it in a repeating band. Second, the roll width (commonly 36 inches, but narrower rolls exist for detailing). Third, the lot or batch code, which determines whether a specific production run had a known issue. Photograph all three, including a tape measure against the roll for scale. If the label is gone, the barrier can often be identified by texture and thickness, but that requires an on-site look.
The OEM-versus-aftermarket call matters here. For a moisture barrier, an IKO replacement matched to the original spec is the clean choice – mixing brands on a continuous membrane creates seam failures. For decorative surfaces and finishes, quality aftermarket equivalents are perfectly acceptable. We also install KraftMaid and pair beautifully with Cambria and Silestone surfaces when the project scope widens beyond the original part. No single answer fits every Enterprise kitchen, which is why the written quote always lists the exact product going in.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your IKO Kitchen Remodeling Is Failing
These five symptoms come up again and again when we walk Enterprise kitchens:
- Soft or spongy floor near the sink or dishwasher. The moisture barrier or seam tape behind or beneath the appliance has failed, and water is reaching the subfloor. Once the wood is soft, the repair scope grows by the day.
- Grout cracking that keeps returning along a backsplash. A barrier holding moisture against the wall pushes the tile line outward as humidity cycles. Regrouting without addressing the barrier just delays the same crack.
- Peeling caulk at the wall-floor transition. This is usually a seam that wasn’t taped correctly under the original IKO membrane, letting moisture wick up the joint. In Enterprise’s dry heat followed by monsoon-season humidity swings, that cycle is harsh on untaped seams.
- Cabinet boxes pulling away from the wall. Water behind a barrier swells the drywall, and the fasteners lose grip. A cabinet re-secure without fixing the source will fail again.
- A musty smell under the sink that returns after cleaning. That’s trapped moisture behind the membrane, not surface mildew. Cleaning the visible area won’t reach it.
Two of these are cosmetic annoyances. Three point to real structural repair underneath.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

IKO-compatible kitchen remodeling in Enterprise runs $14,000 – $45,000 installed, depending on scope. Here’s how the ranges break down:
- Full kitchen remodel: $14,000 – $45,000
- Small kitchen remodel: $9,000 – $20,000
- Cabinet installation: $4,000 – $13,000
- Countertop installation: $2,000 – $6,500
- Backsplash installation: $800 – $2,500
- Kitchen island installation: $3,000 – $10,000
What drives the number up: removing old cabinetry, correcting subfloor damage, re-routing a barrier around new plumbing, and upgrading to slab surfaces. What keeps it down: keeping the existing layout. Our quotes are written line-item – every product named, every step priced, parts and labor transparent. No verbal estimates, no change orders that appear out of nowhere. If a repair or installation fails within 365 days, we return at no charge. That guarantee is in writing on every job.
DIY or Call Us?
There is real safety ground here, and it’s worth stating plainly. The barrier work itself is not dangerous, but the two most common DIY entry points – cutting into a cabinet run near an electrical outlet and prying behind a backsplash – put you within inches of live wiring and plumbing lines that weren’t always routed where the last remodeler said they were. And a barrier installed incorrectly pushes the whole failure downstream.
What you can safely do yourself: photograph the IKO label, measure the roll width, note the lot code, and check for the most obvious signs (soft floor, cracked grout line, musty smell). That’s 15 minutes of honest information that saves us a follow-up.
What goes wrong for DIY: seam taping under humid conditions, applying a barrier over a wet surface, and assuming the visible crack is the whole problem. Well-meant DIY jobs are one of the most common things we’re called to fix. If you’re looking at a full kitchen remodel, the written quote puts a real number in front of you before anything gets ordered. Call (844) 797-6157 to schedule your free estimate.
FAQs

Properly installed and detailed, a quality IKO moisture barrier inside a kitchen runs 15 to 25 years before it needs replacing. In Enterprise, the desert heat and the seasonal monsoon humidity swings are the real drivers – barriers that stay dry and correctly taped reach the long end of that range, and ones behind a leaking sink or no vapor detailing often fail closer to eight years. Call (844) 797-6157 for an on-site look – estimates are free.
Sometimes, yes. A single failed seam near a sink or appliance can often be re-taped and sealed without removing the whole run. Once water has reached the subfloor or swelled drywall, partial repair usually costs more than replacing the affected section properly. Call (844) 797-6157 for a written quote – estimates are free.
A targeted barrier repair or replacement around a sink or appliance zone typically takes one to two days. A full kitchen remodel that includes new cabinetry and surfaces runs one to four weeks depending on scope. You get a written schedule with your written price before any work starts.
We match by product name, roll width, and lot code from your photographed label, then source from IKO distributors in Southern Nevada. We don’t claim to stock IKO inventory or carry it on a service truck – the part is ordered to your specific model. That’s why photographing the label matters, and why we can’t quote accurately without it.
Whether you’re facing a single failed seam or planning a full kitchen remodel, the next step is the same: a written price, before any work starts. Every crew member is background-checked and identity-verified under The Threshold Standard – you’ll receive their name and photo before the visit and see a photo ID badge at the door. A live person answers the phone around the clock, every day of the year. Call (844) 797-6157 to schedule your free estimate for your Enterprise home.
Written by the team at Mason Remodeling Enterprise, serving Enterprise and nearby areas.












