







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Quikrete Bathroom Remodeling: The Enterprise Owner’s Guide
Bathroom remodeling in Enterprise that works with Quikrete materials typically runs $9,000 to $28,000 installed, and it’s planned work, not emergency work, so expect a scheduled start date after your free estimate, not a same-day crew. We’re an independent service provider, not affiliated with Quikrete, and we’ll say plainly where the brand fits and where it doesn’t.

Owners in Enterprise usually find out something is wrong the slow way. A tub surround that was set with the wrong mortar starts to flex underfoot. Grout lines near the shower pan turn dark and crumbly. A patch of thinset under floor tile sounds hollow when you tap it. Or a small leak from a failed shower pan shows up as a soft spot in the hall drywall a room away. That soft spot is the symptom. The Quikrete product underneath, or the way it was installed, is the cause.
Key Takeaways
- Full bathroom remodels in Enterprise run $9,000 to $28,000; small bathrooms run $5,000 to $12,000.
- Quikrete makes mortar, concrete patch, and setting materials, not tile or fixtures. The brand matters most at the substrate layer, where failures hide.
- You’ll get a written price before any work starts, on every project. No verbal estimates that grow on the final bill.
- Every job is covered by the 365-Day Done Right Promise: if it’s not right within 365 days of the completion date, we make it right at no cost.
Which Quikrete Models This Applies To

Quikrete is a materials brand, so the “model” matchup isn’t a serial number on a box. It’s about which Quikrete product was specified for each layer of your bathroom. That’s the first thing we check, and it’s where a lot of Enterprise remodels go wrong.
Here’s how it breaks down by layer:
- Tile setting and bonding: Quikrete makes mortar mixes for bedding and repair work. On a wet bathroom floor or a shower wall, the mix and the cure matter more than the label. A mortar that sets too fast in a hot garage won’t bond the way it should once it hits the wall.
- Concrete patching and leveling: Quikrete patch products are common for repairing a slab before tile goes down. On an older Enterprise slab with hairline cracks, the wrong patch can telegraph a crack right back up through the new tile within a season.
- Shower pan and substrate prep: This is the layer nobody sees and the one that fails first. A pan that wasn’t sloped and sealed correctly will leak long before the tile above it looks wrong.
How to identify what you have: look at the bag or bucket label if you kept it, and measure the actual thickness of the setting bed under the tile. A quarter-inch bed and a half-inch bed need different products. If you don’t have the label, a photo of the exposed surface tells us most of what we need.
On the OEM-versus-aftermarket question: with setting materials, the brand less often fails than the specification does. A quality alternative mix installed to the right depth and cure time outlasts a premium brand installed wrong every time. We specify the product to the job, every time, and we tell you which one and why in the written price.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Quikrete Bathroom Remodeling Is Failing
These are the symptoms we see most often when we walk into a bathroom in Enterprise where the substrate work didn’t hold.
- Hollow sound when you tap the floor tile. That’s a sign the mortar never fully bonded or cured off-gassing in the heat. It usually means the setting bed lost contact with the tile.
- Grout that crumbles or washes out near the shower. Moisture is getting under the grout and staying there. The tile isn’t the problem; the waterproofing under it is.
- A soft spot or bubbling paint on an adjacent wall. That’s a slow leak from a failed shower pan or a cracked setting bed carrying water sideways. It’s the hint that costs the most to ignore.
- Cracks in floor tile that line up in a straight run. A crack in the slab below has found its way up through the patch and the tile above it.
- A tub surround that flexes or moves. The tile is separated from the wall behind it. Once that happens, water gets behind the tile and the repair gets bigger every month.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Bathroom remodeling in Enterprise runs $9,000 to $28,000, and a small bathroom remodel runs $5,000 to $12,000. The range is wide because the number depends on what’s underneath. A straightforward tear-out and rebuild in the lower range. A rebuild that also corrects a failed shower pan, a cracked slab patch, and water damage behind the wall in the upper range.
Line items to expect in your written price:
- Demo and haul-away, including disposal of the old setting bed.
- Substrate repair and prep: concrete patch, mortar, and waterproofing at the thickness the job needs.
- Tile setting labor and setting materials, with the Quikrete (or equivalent) product named.
- Shower or tub work if the pan is part of the scope. A walk-in shower installation runs $4,500 to $12,000 and a tub-to-shower conversion runs $3,500 to $10,000.
- Fixtures and finishes, including vanity work at $800 to $3,000.
Parts and labor are shown separately, so you can see what the materials cost and what the work costs. You get a written price before any tool is unpacked, and it doesn’t grow on the final bill. Every job carries the 365-Day Done Right Promise: if the work isn’t right within 365 days of the completion date, we make it right at no cost, and a failed repair gets a free return visit.
DIY or Call Us?
Some of this you can safely check. Some of it you shouldn’t touch, and we’d rather tell you straight than have you find out the hard way.
Safe to check yourself:
- Tap along the floor tiles to find hollow spots.
- Look at grout lines near the shower and note where they’re dark or crumbly.
- Press on the tub surround and see if it moves.
- Look for soft drywall or bubbling paint on the wall behind the shower.
- Take photos of the bag label if you have it, and a measurement of the setting bed thickness if you can reach it.
Where DIY goes wrong:
Setting a shower pan and building a waterproofed slope is where homeowners get hurt and where remodels fail. A pan that looks right in the bucket can still leak within a year if the slope or the cure wasn’t right. Water behind a wall doesn’t announce itself; it shows up as rot and mold months later, and by then the repair is three times the size. When in doubt, have it done by someone who’s done it before. Our technicians have up to 22 years of experience, and every one is background-checked and identity-verified under The Threshold Standard, so you’ll know exactly who’s coming. You’ll get that tech’s name and photo before the visit and see a photo ID badge at the door.
Call (844) 797-6157 to schedule your free estimate. A live person answers, any time of day or night.
FAQs

Done right, a properly set tile floor and shower pan should last 15 to 20 years or more. The catch is the substrate, not the tile. In Enterprise’s heat, mortar mixed and stored in a hot garage sets differently, and a setting bed that didn’t cure correctly can begin to fail in as little as a year. The 365-Day Done Right Promise is there for exactly that window. Call (844) 797-6157 for a free estimate and a written price.
Sometimes, yes. If the failure is isolated to a few hollow tiles or a section of crumbling grout, a targeted repair can hold. If the shower pan or the setting bed is the problem, a patch usually buys months, not years, and the water keeps moving behind the wall. The free estimate tells you which case you’re in, in writing. Call (844) 797-6157.
A small bathroom remodel typically runs one to two weeks, and a full bathroom remodel runs two to four weeks, depending on whether we’re replacing the pan and correcting the substrate. This is planned work, so your start date is scheduled after the estimate and confirmed before anyone arrives. Call (844) 797-6157 to get on the schedule.
We specify the product to the job and source it through our material partners, and the written price names the product and the layer it goes on. We don’t carry stock and we don’t claim to. We also work with KraftMaid, Cambria, and Silestone when the project includes cabinetry and surfaces, so the finishes and the substrate are specified together rather than guessed at separately. Call (844) 797-6157 for a free estimate.
If you’ve tapped a hollow tile or spotted a soft spot on the wall behind your shower, the smartest next step is a written price, not a guess. Call Mason Remodeling Enterprise at (844) 797-6157 for a free estimate. You’ll get a live person on the line, a scheduled visit, the name and photo of the technician coming to your door, and a written price before any work starts. Every project is backed by the 365-Day Done Right Promise and a written guarantee with terms stated plainly.
Written by the team at Mason Remodeling Enterprise, serving Enterprise and nearby areas.












